'"> ');

Author Topic: How straight (vertically) does brickwork have to be?  (Read 12163 times)

0 Members and 1 Guest are viewing this topic.

Darola

  • New Member
  • *
  • Posts: 3
How straight (vertically) does brickwork have to be?
« on: August 14, 2015, 07:35:16 am »
Have trawled through building regs but can't find anything that specifies the vertical straightness brickwork should be.

The isolated column built to support the garage between the two doors (double garage) has a kink about one third up, that gives the top a slight lean. I have the inspection next week and would like to go in knowing where I stand.


New Home Expert

  • Global Moderator
  • Guru member
  • *****
  • Posts: 1625
  • Country: england
  • Expert advice for new home buyers
    • New Home Blog
Re: How straight (vertically) does brickwork have to be?
« Reply #1 on: August 15, 2015, 07:50:12 am »
The photo you attached was too big.  It needs to be re-sized (maximum) 1200pix wide and 1000pix high.
The only reference or guide I know of is the NHBC's - "A consistent approach to finishes"

Quote
1.2 - S1 External walls shall be built to appropriate tolerances
(e) plumb of wall
Maximum 8mm out of plumb for walls up to 5m in height, limited to 8mm in a storey height (approx 2.5m).
Maximum 12mm out of plumb for walls over 5m in height, limited to 8mm in a storey height (approx 2.5m).

(f) straightness in section
± 8mm maximum deviation in any 2.5m height of wall.

No doubt it will be "within tolerance"  - a bodging housebuilder's favourite phrase.
But you have seen it and it isnt right. This central pier is supporting the roof structure and is important it is perfectly plumb.
My guess is they built it in or out so it would line through when they got to the lintel?
New Home Blog - New Home Expert is committed to providing help and advice for people having issues with their new homes and difficulties with house builders as well as helping potential buyers reduce the risk of possible problems if they do buy.


Darola

  • New Member
  • *
  • Posts: 3
Re: How straight (vertically) does brickwork have to be?
« Reply #2 on: August 15, 2015, 07:55:04 am »
Can see it fine on my phone (on the post). Also found the building regs on it. Must be within 10mm over 2.5m.

Cheers