New Home Owners And Snagging Forum

Advice on buying a brand new home => Snagging and defects => Topic started by: Ben823 on September 17, 2020, 12:47:41 pm

Title: advice on standards of brickwork...
Post by: Ben823 on September 17, 2020, 12:47:41 pm
1st time poster!

We are in the process of buying a new build house and have been keeping an eye on progress over the last few weeks. We haven't yet exchanged and will be talking to the site manager in the next couple of weeks but I wondered if there are any builders/brickies/surveyors who could give some guidance on the brickwork around the front porch and the method of build...

Photo 1 - I noticed that they had left some of the mortar out and assumed that was to allow for the flashing.
Photo 2 - They then removed a number of bricks.
Photo 3 - Bricks replaced and flashing now installed.

Questions:
Why did they remove the bricks??? (They did the same on the neighbouring property as well)
Can I trust that they have replaced the cavity insulation?
Can I trust that the debris hasn't fallen down the cavity and will cause a problem?
Opinions please on the quality of the pointing. The mortar on the corner bricks are particularly bad... Am I being too picky?

Any words of advice would be greatly appreciated.
Title: Re: advice on standards of brickwork...
Post by: Maxell on September 19, 2020, 06:50:02 pm
Probably cavity trays , the insulation might be blown in later .
Good they are sorting it out.
Title: Re: advice on standards of brickwork...
Post by: New Home Expert on September 21, 2020, 11:05:31 am
Looks like the cavity trays were too low or missing and they have been addressed which is good, especially for an external soffit.
It would seem no cavity insulation is installed but this will (should) be blown in before drylining.

As for the mortar colour, this may weather down (eventually) or it could be tinted. Tea is good for darkening.
Please ensure you have your new home professionally inspected and snagged before you legally complete.
You will need to have the cavity insulation checked by boroscope camera.
Title: Re: advice on standards of brickwork...
Post by: Ben823 on September 24, 2020, 03:45:40 pm
Thank you. I'm surprised they have used 'wool - like' insulation. I thought the Celotex type sheets were normally used nowadays and doesn't bridge the cavity?
Title: Re: advice on standards of brickwork...
Post by: New Home Expert on September 24, 2020, 04:12:05 pm
The wool like is often made out of recycled shredded plastic. It cannot transfer water from one side of the cavity to the other.
Mineral wool and "rockwool" have also been used successfully for years.